Available Variants:
Energy Regulator:
Compliance Standards:
- ASTM D402, IS 1213, IP 27
Scope:
- This apparatus is used for the examination of cut-back asphaltic materials by the distillation test.
Consists of following parts and accessories:
1) Distillation Flask:
- Capacity: 500mL
- Type: Side-arm type having the dimensions shown in Fig. 1 of ASTM D402.
2) Condenser:
- Type: Standard glass-jacketed
- Length: 200 to 300 mm
- Overall tube length: 450 ± 10 mm
3) Electric heater:
- Electric heater with Energy Regulator PT-100 Sensor.
4) Adopter:
- Heavy-wall (1-mm) glass, with reinforced top, having an angle of approximately 105°. The inside diameter at the large end will be approximately 18 mm, and at the small end, not less than 5 mm. The lower surface of the adapter will be on a smooth descending curve from the larger end to the smaller.
5) Shield:
- Lined with 3-mm fire proof insulation and fitted with transparent mica windows, of the form and dimensions shown in Fig. 2 of ASTM D402. It is used to protect the flask from air currents and to reduce radiation. The cover (top) will be made in two parts of 6.4-mm (1⁄4-in) fire proof insulation.
6) Flask and shield support:
- Two 15 cm2 sheets of 16-mesh Chromel wire gauze on a tripod or ring.
7) Receiver:
- 100 ml graduated glass cylinder as receiver
8) Thermometer:
- Glass Thermometer ASTM 8C
9) Thermometer holder:
- Silicon rubber stoppers
2. Digital Controller
Compliance Standards:
- ASTM D402, IS 1213, IP 27, AASHTO T78
Scope:
- This apparatus is used for the examination of cut-back asphaltic materials by the distillation test.
Consists of following parts and accessories:
1) Distillation Flask:
- Capacity: 500mL
- Type: Side-arm type having the dimensions shown in Fig. 1 of ASTM D402.
2) Condenser:
- Type: Standard glass-jacketed
- Length: 200 to 300 mm
- Overall tube length: 450 ± 10 mm
3) Electric heater with Digital Temperature controller:
- Electric heater with Microprocessor based AUTO-TUNE PID Digital temperature controller cum indicator with PT-100 Sensor.
4) Adopter:
- Heavy-wall (1-mm) glass, with reinforced top, having an angle of approximately 105°. The inside diameter at the large end will be approximately 18 mm, and at the small end, not less than 5 mm. The lower surface of the adapter will be on a smooth descending curve from the larger end to the smaller.
5) Shield:
- Lined with 3-mm fire proof insulation and fitted with transparent mica windows, of the form and dimensions shown in Fig. 2 of ASTM D402. It is used to protect the flask from air currents and to reduce radiation. The cover (top) will be made in two parts of 6.4-mm (1⁄4-in) fire proof insulation.
6) Flask and shield support:
- Two 15 cm2 sheets of 16-mesh Chromel wire gauze on a tripod or ring.
7) Receiver:
- 100 ml graduated glass cylinder as receiver
8) Thermometer:
- Glass Thermometer ASTM 8C
9) Thermometer holder:
- Silicon rubber stoppers
Technical Specification:
- Overall Dimensions: 11" x 11" x 23" (L x W x H)
- Weight [kg]: 14 Kg